These bar ends by Éclat are both incredibly straightforward and highly durable. Their longevity is ensured by the "over-the-bar" instead of the "into-the-bar" design.
The design incorporates expanding wedges for hassle-free installation using a 4 mm hex bolt.
Steven OstranderRenton, United StatesVerified Buyer5 of 5ThanksAndres VelezStaten island, United StatesVerified Buyer5 of 5Need to buy more eclat teck bar ends very niceVan SayGINESTASVerified Buyer3 of 5How long will they last when the bike often falls into nose manual and hang five mdrr it never lasts enough but it's better than classic bar ends!!!O. NicolaiFerentino, ItalyVerified Buyer5 of 5👍👍👍👍Sjoerd van VelthovenPijnacker, NetherlandsVerified Buyer4 of 5Doing what they need to doAndreas UnkaufEhlscheid, GermanyVerified Buyer5 of 5I can only fully recommend Eclat!David ZimmermannStendal, GermanyVerified Buyer5 of 5Top as alwaysLucas BottiBiebesheim am Rhein, GermanyVerified Buyer4 of 5👌🏼Aniol Ferrer FarréBarcelona, SpainVerified Buyer1 of 5They break very easilyReply from SkateProGood afternoon 😊,
Thank you very much for your comment, this is a product for people who are starting in the world of scooter, possibly what happens is that your level is more advanced than initiation, so possibly have not been able to withstand wear.
Possibly you should opt for some models that are more reinforced to suit you better.
We remain at your disposal if you need anything else,
Best regards, Jens MaesTienen, BelgiumVerified Buyer4 of 5It's like a metal bar end, but it doesn't get as sharp if it hits the ground often. If it gets a little sharp it is easy to sand off with a little sandpaper. Other than that, solid bar ends. Definitely recommended if you ride with steel bars. Easy to install and remove back when worn out.
