Scooter Upgrade Kit Basic Edition

Does your scooter need an upgrade? Obtain a fine custom trick scooter with a threadless headset, a one-piece T-bar, a compression system, and two lightweight single clamps!

We have compiled a set of 5 components designed to upgrade threaded scooters. This kit allows you to transform your threaded scooter into a threadless one using ICS compression technology.
A trick scooter equipped with compression spins significantly better and is easier to secure, and the one-piece bar offers greater strength.

The kit includes:
1x District Pro Threadless headset
2x District single clamp (32mm & 35mm)
1x Worx Royal Bar black one-piece T-bar (Alu. 35 mm outer)
1x Worx Royal stunt scooter fork black threadless stunt scooter fork
1x Worx compression kit.
Notice: Grips are not included in this kit; all grips will fit this bar.

Scooters that can be enhanced using this kit:

• JD Bug Pro Scooter
• Razor Pro XX Scooter
• Razor Ultra Pro Lo Scooter
• Roces Kook Trick Scooter
• Slamm Rage Urban
• Grit Extremist Scooter
• Micro Bullet Street Pro 2.0 Scooter
• Grit Extremist Pro Scooter
• Madd Flow Scooter
• Micro Trixx scooter
• Razor Black Label 3.0 Scooter
• Razor Pro III Scooter
• Madd VX2 Pro 2012
• Razor Black Label 4.0 Scooter
• Madd VX2 Team Edition 2012
• Micro MX Park scooter

It is also compatible with:

• Slamm Mischief
• K2 Park Pro Scooter
• Shaun White Trick scooter
• Grit Elite Scooter
• Micro MX Pro OPB Scooter
• District V4 Complete scooter
• Lucky Crew Scooter
• Madd MGP Ninja Scooter
• Madd MGP Ninja 2012 Scooter
• Madd Nitro End of Days 2012
• Madd Nitro Extreme Scooter

*Other scooters might be upgraded as well
*Handlegrips are not included; you may use your current ones or purchase new ones (they fit all bars).
*Required tools: Screwdriver+Hammer+Tape measure+Unbrako key and a bit of mechanical skill ;)
-----------------------------------------------------------------------------------------------------------------------------------
Instructions:
A general understanding of trick scooter assembly is necessary. We suggest consulting our guide before beginning, read Assembling a custom scooter here.
Upon receiving the kit, you must first clean your existing scooter and remove the old headcups from the headtube.

1. Use a screwdriver to dislodge them and insert the new ones using a hammer. Ensure a wooden block is placed between to avoid scratching the deck or new headcups.
2. Insert the headset bearings into the new headcups.
3. Then measure the length of the new stunt scooter fork extending into the bar, measuring from the top of the headset to the starnut already in the bar.
4. Ensure that the compression bolt can engage the starnut to streamline the entire system. If the starnut is not sufficiently recessed, use a screwdriver to drive it deeper. In case the starnut sits too high in the bar, a replacement starnut is provided for use.
5. Adjust the compression to achieve the desired spin.